 |
Fit the backplate
Fix backplates to the wall, leaving a small gap between the backplates at the
corner.
Here we have dropped the backplate down the wall which allows us to fit the uplighting afterwards.
If you don't require uplighting then fit the backplate hard up against the ceiling. Unlike traditional coving where you have to measure and mark the ceiling and wall - there is no marking or measuring required - just put the backplate hard up against the ceiling and attach.
|
|
 |
Clip internal corner onto backplate
Here you can see the second part of the backplate in situ.
The corner then just clips on to the backplate.
|
|
|
 |
Clip in external corner
Here, because we didn't want to go around the wall, we have cut down a standard corner to provide a stop-end - exactly as you would with standard plaster coving.
|
|
|
 |
Measure gap
Measure the gap and cut your coving a little shorter than the length you measured - this will allow space to insert your couplers at each end.
|
|
|
 |
Clip coving onto backplate
Clip your coving fascia onto the backplate.
|
|
|
 |
Clip in joiners - AND YOU'RE DONE !
Just clip in your joiners and your finished.
If your walls are uneven then fit our optional reversible bubble gasket before clipping on the fascia and joiners.
|
|
|
